Product ID:2345B GREEN PRIMER, PARAT B
MSDS Date:12/20/1994
FSC:8010
NIIN:01-347-0916
Kit Part:Y
MSDS Number: BWSZP

NILES CHEMICAL PAINT CO

225 FORT STREET
NILES, MI 49120
US

Emergency Phone: 219-236-5856

Info Phone: 616-683-3377

Preparer: MIKE LICHATOWICH

Cage: 02388

NILES CHEMICAL PAINT

307 NILES, MI 49120 US

Telephone: 616-683-3377/219-236-5856

Cage: 02388

EPOXY RESIN

CAS: 25068-38-6

RTECS: KC2100000

Fraction By Weight: 49%

VM&P NAPHTHA (VAPOR PRESSURE 15 MM HG @ 37.7C)

CAS: 8030-30-6

RTECS: DE3030000

Fraction By Weight: 24%

OSHA PEL 300 PPM

ACGIH TLV: 300 PPM;STEL 400 PPM

TALC

CAS: 14807-96-6

RTECS: MW2700000

Fraction By Weight: 7%

POLYAMIDE

Fraction By Weight: 1-5%

PROPRIETARY INGREDIENTS (MFR STATES UNIDENTIFIED

Fraction By Weight: BALANCE

2.35 LBS/GAL

RTECS: 9999999VO

Routes of Entry: Inhalation:YES Skin:UNKNOWN Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYE: SEVERE
IRRITATION,TEARING,REDNESS,BLURRED VISION. SKIN: REDNESS &
IRRITATION,DEFATTING LEADING TO DERMATITIS. INHAL: NASAL &
RESPIRATORY IRRITATION,CNS DEPRESSION
(DIZZY,DROWSY,WEAK,FATIGUE,CONFU SION)
NAUSEA,HEADACHE,VERTIGO,UNCONSCIOUSNESS,ASPHYXIATION. INGEST: GI
IRRIT,ABDOMINAL PAIN,NAUSEA,VOMITING,DIARRHEA.
Effects of Overexposure:CHRONIC: DUST MAY CAUSE PNUEMOCONIOSIS, LEURAL
THICKENING. TARGET ORGANS: LUNGS, SKIN, EYES, RESPIRATORY SYSTEM,
CNS.
Medical Cond Aggravated by Exposure:NONE KNOWN

First Aid:INHAL:MOVE TO FRESH AIR IMMED.IF BREATH STOPPED,GIVE ARTIF
RESP.GET MED AID ASAP.SKIN:IMMED FLUSH W/PLENTY OF WATER.IF MAT'L
PENETRATES CLOTH,IMMED REMOVE CONTAM CLOTH,FLUSH SKIN W/H2O.GET MED
AID.WAS H CLOTH & DECONTAM SHOES BEFORE REUSE.EYE:IMMED FLUSH W/H2O
AT LEAST 15 MINUTES,LIFT EYELIDS.GET MED AID IMMED.INGEST:DRINK 1-2
GLASSES H2O.DON'T INDUCE VOMIT.SEE DR/POISON CTR IMMED.TREAT
SYMPTOMS.

Flash Point Method:TCC
Flash Point:50.0F,10.0C
Lower Limits:0.9
Upper Limits:6.0
Extinguishing Media:DRY CHEMICAL, FOAM, CO2
Fire Fighting Procedures:WEAR SCBA W/FULL FACEPIECE (POSITIVE PRESSURE
MODE) & FULL PROTECT CLOTH. USE WATER TO COOL CLOSED CNTNR TO
PREVENT PRESSURE BLDUP/AUTO IGNIT/EXPLOSION W/HEAT.
Unusual Fire/Explosion Hazard:KEEP CNTNR CLSD.VAPOR HEAVY,TRAVEL ON
GRND TO IGNIT.KEEP FROM HEAT/IGNIT.CLSD CNTNR EXPLODE W/HEAT.APPLIC
TO HOT SRFCS REQ SPCL CAUTN.DECOMP PRODUCT-HEALTH HZD.

Spill Release Procedures:ELIMINATE IGNITION SOURCE. MINIMIZE BREATHING
VAPOR/AVOID SKIN CONTACT. SMALL: ABOSRB W/INERT MAT'L
(CLAY,SOIL,COMMERCIAL ABSORBENT). SHOVEL LIQ/ABSORBENT INTO
RECOVERY/SALVAGE DRUMS. LRG: DIKE. RECLA IM INTO RECOVERY/SALVAGE
DRUMS OR TANK TRUCK.

Handling and Storage Precautions:AVOID STORAGE IN HIGH TEMPERATURE
AREAS OR NEAR FIRE OR OPEN FLAME. KEEP CONTAINERS CLOSED WHEN NOT
IN USE. AVOID ROUGH HANDLING.
Other Precautions:CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN
EMPTY. DO NOT WELD OR FLAME CUT ON EMPTY DRUMS. SHOCK FROM DROPPING
ANY SPLIT CONTAINER.

Respiratory Protection:WEAR APPROPRIATE (TYPE TC-23C-75) FITTED
HALF-MASK OR FULL FACEPIECE RESPIRATOR DURING/AFTER APPLICATION
UNLESS AIR MONITORING DEMONSTRATES VAPOR/MIST LEVELS BELOW TLV/PEL.
FOLLOW RESPIRATOR MFR'S DIR ECTIONS FOR USE.
Ventilation:KEEP CUTTING OF SURFACE COATED W/PRODUCT.VENT VAPOR FROM BAKING FINISHES
Protective Gloves:CHEMICAL RESISTANT (NITRILE/VITON)GLOVES
Eye Protection:CHEM GOGGLES,SAFETY GLASSES,FACE SHIELDS
Other Protective Equipment:WEAR CHEMICAL RESISTANT (NITRILE OR VITON)
CLOTHING AS NEEDED TO PREVENT SKIN CONTACT.
Work Hygienic Practices:WASH HANDS BEFORE EATING, SMOKING OR USING
RESTROOM. EMPLOYEES SHOULD WASH PROMPTLY WHEN SKIN BECOMES
CONTAMINATED.
Supplemental Safety and Health
REMOVE ANY CLOTHING THAT BECOMES WET (TO AVOID FLAMMABILITY HAZARD) AND
WASH BEFORE REUSE.

HCC:F3
Boiling Pt:B.P. Text:285F,141C
Vapor Density:> AIR
Spec Gravity:1.149
Viscosity:76 - 89 KU
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:SLIGHT
Appearance and Odor:LIQUID, ODOR OF SOLVENTS
Percent Volatiles by Volume:38.26
Corrosion Rate:MINIMAL

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS
Stability Condition to Avoid:HIGH TEMPERATURES
Hazardous Decomposition Products:CAN PRODUCE CARBON MONOXIDE AND/OR
CARBON DIOXIDE.
Conditions to Avoid Polymerization:HIGH TEMPERATURES

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH APPLICABLE LOCAL,
STATE, AND FEDERAL REGULATIONS. EPA HAZARDOUS WASTE CODE: D-001
(IGNITABLE).

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.